Extruder has SNAGS(?) that causes it to mess up rpinting

Ultimi post

RSS

Al Cheddah

(@al-cheddah)

Active Member

Extruder has SNAGS(?) that causes it to mess up rpinting

I just got this Printer last week and tried to get it to work this weekend and it seemed link it was working fine. But when I tried to print Benchy, it seems that the filament hits a snag of some some and it comes and it catches the filament already printed out and cases a big mess. Not sure what the terminology for this is, but it's annoying. Any Ideas?

Postato : 14/04/2020 1:27 am

Statistiche Forum

565 Forum

63.6 K Discussioni

446.2 K Post

20 Online

68.9 K Utenti

Post recenti: Print plate scratched when canceling print during priming line Ultimo utente registrato: Kiley Murphy Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso