Notifications
Clear all
zealousPrototype
zealousPrototype
Skupina: Registrovaný
Přidal se: 2022/08/23
Eminent Member
2
Update: There was another leak. I think it may have been cau...

In forum Hardware, firmware and software help

před 1 year
Diam thanks for the diagram but I already diagnosed a leak. ...

In forum Hardware, firmware and software help

před 1 year
Clean leak in heatblock, heatbreak unscrewed from heatsink

In forum Hardware, firmware and software help

před 1 year
I started the print and it was about 1cm above where it shou...

In forum How do I print this? (Printing help)

před 2 years
Fixing GCode to resume where print stopped

In forum How do I print this? (Printing help)

před 2 years
Update: I cleaned and readjusted the y-axis rods, checked th...

In forum Hardware, firmware and software help

před 2 years
Hey agleknovic, I agree with fuchsr that the first layer in ...

In forum Hardware, firmware and software help

před 2 years
Hello, To clarify, you have a good first layer calibration, ...

In forum Hardware, firmware and software help

před 2 years
Y-Axis Clicking

In forum Hardware, firmware and software help

před 2 years
Solution was more force on the snap fit pin while supporting...

In forum Assembly and first prints troubleshooting

před 2 years
2Pin power connector for hot end stuck in the PCB

In forum Assembly and first prints troubleshooting

před 2 years
Lines and blobs on prints

In forum How do I print this? (Printing help)

před 2 years
Like cwbullet said, slowing the print down and increasing co...

In forum How do I print this? (Printing help)

před 2 years
Good to know, if replacing the entire extruder fixed the pr...

In forum How do I print this? (Printing help)

před 2 years
Thanks for the reply, what am I looking for in the gear teet...

In forum How do I print this? (Printing help)

před 2 years
Does my Prusa MINI Extruder Driven Gear (Filament Spur) need...

In forum How do I print this? (Printing help)

před 2 years
Thanks for the reply. I'm unsure if the filament is perfectl...

In forum How do I print this? (Printing help)

před 2 years
Hello Do you have any photos?

In forum How do I print this? (Printing help)

před 2 years
Gaps in first layer

In forum How do I print this? (Printing help)

před 2 years
Stránka 1 / 2
Share: