Notifiche
Cancella tutti
Yanksy
Gruppo: Registrato
Registrato: 2023/01/05
Active Member
1
|
Thanks for the info.
I suppose I will avoid hollowing it,... Nel forum PrusaSlicer |
2 years fa | |
|
Oh I see.I like hollowing them to save a lot on time and fil... Nel forum PrusaSlicer |
2 years fa | |
|
Where did hollowing in Prusa go? Nel forum PrusaSlicer |
2 years fa | |
|
There is the file in dropbox Heres another Nel forum PrusaSlicer |
2 years fa | |
|
Doesnt look like the file attached. Says max allowed is 10mb... Nel forum PrusaSlicer |
2 years fa | |
|
Ok here is an example of it happening. Thanks Nel forum PrusaSlicer |
2 years fa | |
|
Switching from Cura to Prusa questions (LK5) Nel forum PrusaSlicer |
2 years fa | |
|
Block supports/layer Nel forum PrusaSlicer |
2 years fa | |
|
Change at Z Nel forum PrusaSlicer |
2 years fa | |
|
OK I will check that out. Thanks! Nel forum PrusaSlicer |
2 years fa | |
|
"Used Filament" estimates not showing Nel forum PrusaSlicer |
2 years fa |