Avisos
Vaciar todo
Yanksy
Grupo: Registrado
Registrado: 2023/01/05
Active Member
1
|
Thanks for the info.
I suppose I will avoid hollowing it,... En el foro PrusaSlicer |
hace 3 years | |
|
Oh I see.I like hollowing them to save a lot on time and fil... En el foro PrusaSlicer |
hace 3 years | |
|
Where did hollowing in Prusa go? En el foro PrusaSlicer |
hace 3 years | |
|
There is the file in dropbox Heres another En el foro PrusaSlicer |
hace 3 years | |
|
Doesnt look like the file attached. Says max allowed is 10mb... En el foro PrusaSlicer |
hace 3 years | |
|
Ok here is an example of it happening. Thanks En el foro PrusaSlicer |
hace 3 years | |
|
Switching from Cura to Prusa questions (LK5) En el foro PrusaSlicer |
hace 3 years | |
|
Block supports/layer En el foro PrusaSlicer |
hace 3 years | |
|
Change at Z En el foro PrusaSlicer |
hace 3 years | |
|
OK I will check that out. Thanks! En el foro PrusaSlicer |
hace 3 years | |
|
"Used Filament" estimates not showing En el foro PrusaSlicer |
hace 3 years |