Notifications
Clear all
Yanksy
Groupe: Enregistré
A(ont) rejoint: 2023/01/05
Active Member
1
|
Thanks for the info.
I suppose I will avoid hollowing it,... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Oh I see.I like hollowing them to save a lot on time and fil... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Where did hollowing in Prusa go? Dans le forum PrusaSlicer |
il y a 3 years | |
|
There is the file in dropbox Heres another Dans le forum PrusaSlicer |
il y a 3 years | |
|
Doesnt look like the file attached. Says max allowed is 10mb... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Ok here is an example of it happening. Thanks Dans le forum PrusaSlicer |
il y a 3 years | |
|
Switching from Cura to Prusa questions (LK5) Dans le forum PrusaSlicer |
il y a 3 years | |
|
Block supports/layer Dans le forum PrusaSlicer |
il y a 3 years | |
|
Change at Z Dans le forum PrusaSlicer |
il y a 3 years | |
|
OK I will check that out. Thanks! Dans le forum PrusaSlicer |
il y a 3 years | |
|
"Used Filament" estimates not showing Dans le forum PrusaSlicer |
il y a 3 years |