Notifications
Clear all
Yanksy
Group: Registered
Joined: 2023/01/05
Active Member
1
|
Thanks for the info.
I suppose I will avoid hollowing it,... In forum PrusaSlicer |
3 years ago | |
|
Oh I see.I like hollowing them to save a lot on time and fil... In forum PrusaSlicer |
3 years ago | |
|
Where did hollowing in Prusa go? In forum PrusaSlicer |
3 years ago | |
|
There is the file in dropbox Heres another In forum PrusaSlicer |
3 years ago | |
|
Doesnt look like the file attached. Says max allowed is 10mb... In forum PrusaSlicer |
3 years ago | |
|
Ok here is an example of it happening. Thanks In forum PrusaSlicer |
3 years ago | |
|
Switching from Cura to Prusa questions (LK5) In forum PrusaSlicer |
3 years ago | |
|
Block supports/layer In forum PrusaSlicer |
3 years ago | |
|
Change at Z In forum PrusaSlicer |
3 years ago | |
|
OK I will check that out. Thanks! In forum PrusaSlicer |
3 years ago | |
|
"Used Filament" estimates not showing In forum PrusaSlicer |
3 years ago |