|
Horzontal lines at corners with patterns Nel forum How do I print this? (Printing help) |
7 months fa |
|
That sounds like the extruder is clicking (grinding on the f... Nel forum Hardware, firmware and software help |
3 years fa |
|
All of my miniature prints have been sliced with Prusa Slice... Nel forum How do I print this? (Printing help) |
4 years fa |
|
Like mentioned above I've found that supports are much easie... Nel forum How do I print this? (Printing help) |
4 years fa |
|
I haven't had any print failures this weekend after printing... Nel forum Hardware, firmware and software help |
4 years fa |
|
The new heat bed thermistor showed up today and I got it ins... Nel forum Hardware, firmware and software help |
4 years fa |
|
That is what was happening to me. They had me preheat the be... Nel forum Hardware, firmware and software help |
4 years fa |
|
Unfortunately I had another failure with the same exact erro... Nel forum Hardware, firmware and software help |
4 years fa |
|
I did test the resistance for the wires. The thermistor was ... Nel forum Hardware, firmware and software help |
4 years fa |
|
I was printing PLA nozzle 210 / bed 60 Nel forum Hardware, firmware and software help |
4 years fa |
|
I had a print fail last night, roughly 17 hours into a 25 ho... Nel forum Hardware, firmware and software help |
4 years fa |
|
@pascal-l4 Any luck solving this problem? I am having the sa... Nel forum Hardware, firmware and software help |
4 years fa |
|
Thank you for taking the time to post those videos. It is he... Nel forum General discussion, announcements and releases |
4 years fa |
