|
Horzontal lines at corners with patterns En el foro How do I print this? (Printing help) |
hace 7 months |
|
That sounds like the extruder is clicking (grinding on the f... En el foro Hardware, firmware and software help |
hace 3 years |
|
All of my miniature prints have been sliced with Prusa Slice... En el foro How do I print this? (Printing help) |
hace 4 years |
|
Like mentioned above I've found that supports are much easie... En el foro How do I print this? (Printing help) |
hace 4 years |
|
I haven't had any print failures this weekend after printing... En el foro Hardware, firmware and software help |
hace 4 years |
|
The new heat bed thermistor showed up today and I got it ins... En el foro Hardware, firmware and software help |
hace 4 years |
|
That is what was happening to me. They had me preheat the be... En el foro Hardware, firmware and software help |
hace 4 years |
|
Unfortunately I had another failure with the same exact erro... En el foro Hardware, firmware and software help |
hace 4 years |
|
I did test the resistance for the wires. The thermistor was ... En el foro Hardware, firmware and software help |
hace 4 years |
|
I was printing PLA nozzle 210 / bed 60 En el foro Hardware, firmware and software help |
hace 4 years |
|
I had a print fail last night, roughly 17 hours into a 25 ho... En el foro Hardware, firmware and software help |
hace 4 years |
|
@pascal-l4 Any luck solving this problem? I am having the sa... En el foro Hardware, firmware and software help |
hace 4 years |
|
Thank you for taking the time to post those videos. It is he... En el foro General discussion, announcements and releases |
hace 4 years |
