Prusa3D Forum

Notifications

Clear all

wicax

Groupe: Enregistré

A(ont) rejoint: 2020/07/14

Active Member

	I tried cleaning with dish soap and that worked very well so... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I will try that and get back to you with the results. One th... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thank you for the response. Helps to just know I might be on... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Amazon basics pla. Not the best quality I know, but these fi... Dans le forum How do I print this? (Printing help)	il y a 3 years
	First layer calibration help Dans le forum How do I print this? (Printing help)	il y a 3 years
	Y axis Layer shifting Dans le forum How do I print this? (Printing help)	il y a 4 years
	This is hopefully a better video for hearing the clicking. I... Dans le forum Hardware, firmware and software help	il y a 4 years
	@karl-herbert Here is what you posted on my other post: Hell... Dans le forum Hardware, firmware and software help	il y a 4 years
	Extruder clicking Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

559 Forums

62.8 K Sujets

442.4 K Messages

21 En-ligne

67.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé