Notifications
Clear all
WDLandry
WDLandry
Group: Registered
Joined: 2025/03/29
Trusted Member
3
Thanks for you're reply. The phase stepping did lower some o...

In forum Hardware, firmware and software help

2 weeks ago
Another thread about homing issues but at my wits end

In forum Hardware, firmware and software help

2 weeks ago
- Slicer - I like to mess around with the slicer settings bu...

In forum General discussion, announcements and releases

2 weeks ago
Kind of frustrating alright with the poly maker. I wonder if...

In forum General discussion, announcements and releases

2 weeks ago
I’ve had the opposite situation with a single reel sunlu dri...

In forum General discussion, announcements and releases

2 weeks ago
Good point and clarification to make. When I refer to vacuum...

In forum General discussion, announcements and releases

4 weeks ago
I would say it’s a good place to start, and was exactly what...

In forum General discussion, announcements and releases

4 weeks ago
You'd need an oven to get anything above 70 degrees C really...

In forum General discussion, announcements and releases

4 weeks ago
Having a dryer handy is definitely worth it. As mentioned, t...

In forum General discussion, announcements and releases

4 weeks ago
Bondtech cite Formnext 2025 as the official launch for INDX....

In forum General discussion, announcements and releases

1 month ago
I love how our current options as core one owners are relati...

In forum General discussion, announcements and releases

1 month ago
Bondtech already stated they will launch INDX, so it could b...

In forum General discussion, announcements and releases

1 month ago
Any change will require r+d. Those nextruder nozzles have 3 ...

In forum General discussion, announcements and releases

1 month ago
Based on the fact that Bondtech are also teasing this, its a...

In forum General discussion, announcements and releases

1 month ago
Exact same use case I’m looking for. Multi-colour is a nice ...

In forum General discussion, announcements and releases

1 month ago
This is a very good point. I have been doing it before start...

In forum General discussion, announcements and releases

2 months ago
I’ve been checking once a week. I have noticed I’ve had to a...

In forum General discussion, announcements and releases

2 months ago
Agree, it’s not bending due to normal activity on the printe...

In forum General discussion, announcements and releases

2 months ago
The position of the washer compensates for the bracket not b...

In forum General discussion, announcements and releases

2 months ago
I did do the phase stepping post tuning but will try again l...

In forum General discussion, announcements and releases

2 months ago
Page 1 / 3
Share: