Activité
 
Notifications
Clear all
waino
waino
Groupe: Enregistré
A(ont) rejoint: 2017/10/03
Eminent Member
2
Yes, it seems to work at least here ok with the 40W (standar...

Dans le forum Hardware, firmware and software help

il y a 1 month
I had a similar issue a few days ago (I did post my comments...

Dans le forum Hardware, firmware and software help

il y a 10 months
I really wonder if anyone really bothered to test this MMU2S...

Dans le forum Hardware, firmware and software help

il y a 10 months
I'm personally pretty much done with prusa products. I am ve...

Dans le forum Hardware, firmware and software help

il y a 1 year
I happen to have an early model Mk3 (later upgraded to MK3S+...

Dans le forum General discussion, announcements and releases

il y a 1 year
Honestly, I had nothing but problems in tuning my extruder i...

Dans le forum General discussion, announcements and releases

il y a 2 years
It's great to see some practical examples & pictures how...

Dans le forum Hardware, firmware and software help

il y a 2 years
I just find it very annoying that the upgrade is still being...

Dans le forum Hardware, firmware and software help

il y a 2 years
No. If there would be, I would have bought it myself as well...

Dans le forum Hardware, firmware and software help

il y a 2 years
I have to say that I'm little bit dumbfounded that this issu...

Dans le forum Hardware, firmware and software help

il y a 3 years
Does anyone have more detailed information about the correct...

Dans le forum Hardware, firmware and software help

il y a 3 years
I have to say that based on the above comments, I'm very int...

Dans le forum General discussion, announcements and releases

il y a 6 years
The reason why I personally seem to have a need to use Cura ...

Dans le forum General discussion, announcements and releases

il y a 6 years
Do check the following threads: or I don't get it why th...

Dans le forum Hardware, firmware and software help

il y a 7 years
Unfortunately, this is exactly the same problem that I've be...

Dans le forum Software (Archive)

il y a 7 years
Just completed a firmware downgrade using Octoprint and the ...

Dans le forum Software (Archive)

il y a 7 years
Can someone verify if the MK3 needs any changes for the firm...

Dans le forum Software (Archive)

il y a 7 years
I have seen these wierd behaviours with the RC4 b143 firmwar...

Dans le forum Others (Archive)

il y a 7 years
I had exactly the same problem when trying to run the initia...

Dans le forum Others (Archive)

il y a 7 years
My order 4956 got a UPS label on the 20th and still hasn't s...

Dans le forum General discussion, announcements and releases

il y a 7 years
Page 1 / 2
Partager :