Aktivität
 
Benachrichtigungen
Alles löschen
vaxxi
vaxxi
Gruppe: Registriert
Beigetreten: 2017/09/25
Estimable Member
4
I get a warning that my printer board has changed and that o...

Im Forum Hardware, firmware and software help

Vor 7 years
Based on the 8.3 naming format of the file list, you're uplo...

Im Forum Others (Archive)

Vor 7 years
Borrow a little nail polish and paint over the scratches. ...

Im Forum Others (Archive)

Vor 7 years
Huge topic on this problem can be found here.

Im Forum Others (Archive)

Vor 7 years
Re: Flash firmware from Raspberry Pi?

Im Forum Others (Archive)

Vor 7 years
For the filament exiting the side of the extruder, there's a...

Im Forum Others (Archive)

Vor 7 years
Nope, canceling your order or not buying. The rest is dust i...

Im Forum Others (Archive)

Vor 7 years
Probably because it's the last "weapon" in the consumer's ha...

Im Forum Others (Archive)

Vor 7 years
After being a forum member reading it daily since the MK3 wa...

Im Forum Others (Archive)

Vor 7 years
Printing spare parts is a very good test for a new printer. ...

Im Forum Others (Archive)

Vor 7 years
Re: Feature Request: Total Up Time for Printer

Im Forum Software (Archive)

Vor 7 years
There are "virtual endstops" generated based on the stepper ...

Im Forum Others (Archive)

Vor 7 years
It's been asked several times, but there was never a clear a...

Im Forum Others (Archive)

Vor 7 years
Thermistor cartridge from E3D. Will need cutting off the con...

Im Forum Others (Archive)

Vor 7 years
Signed up in September, received exactly 3 emails since then...

Im Forum Others (Archive)

Vor 7 years
Yes 🙂

Im Forum Others (Archive)

Vor 7 years
You're not the first, see Filament detector overheating.

Im Forum Others (Archive)

Vor 7 years
I don't see how it could help with bed adhesion. A brim, yes...

Im Forum Print tips (Archive)

Vor 7 years
Reading the manual usually helps: It's said that it can so...

Im Forum Print tips (Archive)

Vor 7 years
The extruder idler is on the swinging "carriage", as describ...

Im Forum Others (Archive)

Vor 7 years
Seite 2 / 6
Teilen: