Notifications
Clear all
username48
Grupa: Zarejestrowany
Dołączył: 2024/04/28
Active Member
1
| Not sure if this the right place to post a bug report... but... | 4 months temu | |
|
Goofy Behavior With Multi-Extruders & Brims (Possible Bug?) In forum PrusaSlicer |
10 months temu | |
|
Yes the sharp corners are a pretty silly oversight. My XL sh... In forum Hardware, firmware and software help |
2 years temu | |
|
I too have had consistent issues with adhesion on the textur... In forum Hardware, firmware and software help |
2 years temu |