Notifications
Clear all
username48
Skupina: Registrovaný
Přidal se: 2024/04/28
Active Member
1
| Not sure if this the right place to post a bug report... but... | před 4 months | |
|
Goofy Behavior With Multi-Extruders & Brims (Possible Bug?) In forum PrusaSlicer |
před 10 months | |
|
Yes the sharp corners are a pretty silly oversight. My XL sh... In forum Hardware, firmware and software help |
před 2 years | |
|
I too have had consistent issues with adhesion on the textur... In forum Hardware, firmware and software help |
před 2 years |