|
@andrew.e7 did you try blasting it with a hair dryer? I coul... En el foro Hardware, firmware and software help |
hace 7 years |
|
Prusa support helped me removing the heatsink from the extru... En el foro Hardware, firmware and software help |
hace 7 years |
|
Thanks for the suggestion! I have not been able to pull it o... En el foro Hardware, firmware and software help |
hace 7 years |
|
Ah sorry, I should have been more specific. I cannot remove ... En el foro Hardware, firmware and software help |
hace 7 years |
|
I removed the blob by blowing on the tube still sitting in t... En el foro Hardware, firmware and software help |
hace 7 years |
|
Use heat and pull it out the top. You're going to have to r... En el foro Hardware, firmware and software help |
hace 7 years |
|
Thanks I will do that. I am pretty sure I had the fan the ri... En el foro Hardware, firmware and software help |
hace 7 years |
|
Thanks for the replies 🙂 Some more investigation over the w... En el foro Hardware, firmware and software help |
hace 7 years |
|
Filament stuck in cold end En el foro Hardware, firmware and software help |
hace 7 years |
