Prusa3D Forum

Benachrichtigungen

Alles löschen

unverbraucht

Gruppe: Registriert

Beigetreten: 2018/01/14

Active Member

	@andrew.e7 did you try blasting it with a hair dryer? I coul... Im Forum Hardware, firmware and software help	Vor 7 years
	Prusa support helped me removing the heatsink from the extru... Im Forum Hardware, firmware and software help	Vor 7 years
	Thanks for the suggestion! I have not been able to pull it o... Im Forum Hardware, firmware and software help	Vor 7 years
	Ah sorry, I should have been more specific. I cannot remove ... Im Forum Hardware, firmware and software help	Vor 7 years
	I removed the blob by blowing on the tube still sitting in t... Im Forum Hardware, firmware and software help	Vor 7 years
	Use heat and pull it out the top. You're going to have to r... Im Forum Hardware, firmware and software help	Vor 7 years
	Thanks I will do that. I am pretty sure I had the fan the ri... Im Forum Hardware, firmware and software help	Vor 7 years
	Thanks for the replies 🙂 Some more investigation over the w... Im Forum Hardware, firmware and software help	Vor 7 years
	Filament stuck in cold end Im Forum Hardware, firmware and software help	Vor 7 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.8 K Beiträge

20 Online

67.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen