Prusa3D Forum

Notifications

Clear all

unverbraucht

Skupina: Registrovaný

Přidal se: 2018/01/14

Active Member

	@andrew.e7 did you try blasting it with a hair dryer? I coul... In forum Hardware, firmware and software help	před 7 years
	Prusa support helped me removing the heatsink from the extru... In forum Hardware, firmware and software help	před 7 years
	Thanks for the suggestion! I have not been able to pull it o... In forum Hardware, firmware and software help	před 7 years
	Ah sorry, I should have been more specific. I cannot remove ... In forum Hardware, firmware and software help	před 7 years
	I removed the blob by blowing on the tube still sitting in t... In forum Hardware, firmware and software help	před 7 years
	Use heat and pull it out the top. You're going to have to r... In forum Hardware, firmware and software help	před 7 years
	Thanks I will do that. I am pretty sure I had the fan the ri... In forum Hardware, firmware and software help	před 7 years
	Thanks for the replies 🙂 Some more investigation over the w... In forum Hardware, firmware and software help	před 7 years
	Filament stuck in cold end In forum Hardware, firmware and software help	před 7 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.8 K Příspěvky

18 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed