Prusa3D Forum

Notifications

Clear all

Grupa: Zarejestrowany

Dołączył: 2020/07/04

Active Member

	I replaced the thermistor with this one on Amazon, and the p... In forum Hardware, firmware and software help	3 years temu
	Thanks, everyone. Per @karl-herbert's suggestion, I went wi... In forum Hardware, firmware and software help	3 years temu
	Is this connector safe for the power supply on an MK3? In forum Hardware, firmware and software help	3 years temu
	Just a wild guess -- could the machine with the flaw need to... In forum Hardware, firmware and software help	3 years temu
	A PID calibration did not help. I think something is wrong i... In forum Hardware, firmware and software help	3 years temu
	Significant temp fluctuations at start of print In forum Hardware, firmware and software help	3 years temu
	I'm also experiencing frequent clogs since I upgraded my MK3... In forum Hardware, firmware and software help	4 years temu
	@kyle-a3 Clicking on the exclamation mark only prompts me to... In forum PrusaSlicer	4 years temu
	Exclamation mark near stl, but no explanation In forum PrusaSlicer	4 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.3 K Posty

25 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte