Prusa3D Forum

Notifiche

Cancella tutti

Gruppo: Registrato

Registrato: 2020/07/04

Active Member

	I replaced the thermistor with this one on Amazon, and the p... Nel forum Hardware, firmware and software help	3 years fa
	Thanks, everyone. Per @karl-herbert's suggestion, I went wi... Nel forum Hardware, firmware and software help	3 years fa
	Is this connector safe for the power supply on an MK3? Nel forum Hardware, firmware and software help	3 years fa
	Just a wild guess -- could the machine with the flaw need to... Nel forum Hardware, firmware and software help	3 years fa
	A PID calibration did not help. I think something is wrong i... Nel forum Hardware, firmware and software help	3 years fa
	Significant temp fluctuations at start of print Nel forum Hardware, firmware and software help	3 years fa
	I'm also experiencing frequent clogs since I upgraded my MK3... Nel forum Hardware, firmware and software help	4 years fa
	@kyle-a3 Clicking on the exclamation mark only prompts me to... Nel forum PrusaSlicer	4 years fa
	Exclamation mark near stl, but no explanation Nel forum PrusaSlicer	4 years fa

Statistiche Forum

559 Forum

63 K Discussioni

443.3 K Post

23 Online

67.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso