Prusa3D Forum

Notifications

Clear all

Groupe: Enregistré

A(ont) rejoint: 2020/07/04

Active Member

	I replaced the thermistor with this one on Amazon, and the p... Dans le forum Hardware, firmware and software help	il y a 3 years
	Thanks, everyone. Per @karl-herbert's suggestion, I went wi... Dans le forum Hardware, firmware and software help	il y a 3 years
	Is this connector safe for the power supply on an MK3? Dans le forum Hardware, firmware and software help	il y a 3 years
	Just a wild guess -- could the machine with the flaw need to... Dans le forum Hardware, firmware and software help	il y a 3 years
	A PID calibration did not help. I think something is wrong i... Dans le forum Hardware, firmware and software help	il y a 3 years
	Significant temp fluctuations at start of print Dans le forum Hardware, firmware and software help	il y a 3 years
	I'm also experiencing frequent clogs since I upgraded my MK3... Dans le forum Hardware, firmware and software help	il y a 4 years
	@kyle-a3 Clicking on the exclamation mark only prompts me to... Dans le forum PrusaSlicer	il y a 4 years
	Exclamation mark near stl, but no explanation Dans le forum PrusaSlicer	il y a 4 years

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

25 En-ligne

67.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé