Prusa3D Forum

Notifications

Clear all

Groupe: Enregistré

A(ont) rejoint: 2021/04/21

Active Member

	No, The bed is not flat when isolated. It's why I decide to ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Not all because of the use of springs. The reason why I trie... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	I successfully printed some things this half day, and it loo... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Hold a straight edge, a ruler, against the bed and check for... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Has it been resolved? After re-assembled the original isola... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	This is a new build? Not a rebuild? If the new heatbed is u... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	@dan-rogers Yes I have enabled 7x7, and adjusted live Z man... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Yes, it comes with nine 6mm isolation columns. The first lay... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Strange first layer problem Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

9 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé