Prusa3D Forum

Benachrichtigungen

Alles löschen

Gruppe: Registriert

Beigetreten: 2021/04/21

Active Member

	No, The bed is not flat when isolated. It's why I decide to ... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	Not all because of the use of springs. The reason why I trie... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	I successfully printed some things this half day, and it loo... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	Hold a straight edge, a ruler, against the bed and check for... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	Has it been resolved? After re-assembled the original isola... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	This is a new build? Not a rebuild? If the new heatbed is u... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	@dan-rogers Yes I have enabled 7x7, and adjusted live Z man... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	Yes, it comes with nine 6mm isolation columns. The first lay... Im Forum Assembly and first prints troubleshooting	Vor 4 years
	Strange first layer problem Im Forum Assembly and first prints troubleshooting	Vor 4 years

Forums-Statistiken

565 Foren

63.6 K Themen

446.2 K Beiträge

20 Online

68.9 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen