Prusa3D Forum

Notifications

Clear all

Group: Registered

Joined: 2021/04/21

Active Member

	No, The bed is not flat when isolated. It's why I decide to ... In forum Assembly and first prints troubleshooting	4 years ago
	Not all because of the use of springs. The reason why I trie... In forum Assembly and first prints troubleshooting	4 years ago
	I successfully printed some things this half day, and it loo... In forum Assembly and first prints troubleshooting	4 years ago
	Hold a straight edge, a ruler, against the bed and check for... In forum Assembly and first prints troubleshooting	4 years ago
	Has it been resolved? After re-assembled the original isola... In forum Assembly and first prints troubleshooting	4 years ago
	This is a new build? Not a rebuild? If the new heatbed is u... In forum Assembly and first prints troubleshooting	4 years ago
	@dan-rogers Yes I have enabled 7x7, and adjusted live Z man... In forum Assembly and first prints troubleshooting	4 years ago
	Yes, it comes with nine 6mm isolation columns. The first lay... In forum Assembly and first prints troubleshooting	4 years ago
	Strange first layer problem In forum Assembly and first prints troubleshooting	4 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.2 K Posts

22 Online

68.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed