Notifications
Clear all
tshonka
Skupina: Registrovaný
Přidal se: 2019/09/23
Active Member
1
|
Even with lower printing speed I get this result In forum Hardware, firmware and software help |
před 5 years | |
|
Fillings not sticking to bottem print In forum Hardware, firmware and software help |
před 5 years | |
| Problem with calibration of Z axis (extruder touches the pla... | před 6 years | |
| thanks, it solved the issue 🙂 | před 6 years | |
| Problem with self test: heater/thermistor not connected? | před 6 years |