Čeština
Fóra
Uživatelé
tsamisa
Aktivita
 
Notifications
Clear all
tsamisa
tsamisa
Skupina: Registrovaný
Přidal se: 2019/01/30
Reputable Member
5
Profile Aktivita
About the constant failing on multiple loading i found out (...

In forum Assembly and first prints troubleshooting

 před 6 years
What do you think about e3d,s toolchanger? I know its going ...

In forum General discussion, announcements and releases

 před 6 years
Non soluble supports in multi mode

In forum How do I print this? (Printing help)

 před 6 years
Well i got my first end to end successful print with a 0.4 n...

In forum How do I print this? (Printing help)

 před 6 years
i guess you are right about the actually reading a lot into ...

In forum How do I print this? (Printing help)

 před 6 years
After playing around with settings more it seems that the pr...

In forum How do I print this? (Printing help)

 před 6 years
I tried the speed recommendations and reducing to 50% speed ...

In forum How do I print this? (Printing help)

 před 6 years
i was using the 7x7 but return back to 3x3 since it wasn't m...

In forum How do I print this? (Printing help)

 před 6 years
Thanks for your recommendations. I already reduced the volum...

In forum How do I print this? (Printing help)

 před 6 years
Printing with colorfabb copperfill

In forum How do I print this? (Printing help)

 před 6 years
I finally, with the help and patience of the support , limit...

In forum General discussion, announcements and releases

 před 6 years
I have the same problem with you with PVA (along with loadin...

In forum Hardware, firmware and software help

 před 6 years
Yet another loading issue with MMU2S.

In forum General discussion, announcements and releases

 před 6 years
I really sympathize. After following the excellent instructi...

In forum General discussion, announcements and releases

 před 6 years
Stránka 13 / 13
Share: