tsamisa – Aktivita – Prusa3D Forum

Notifications

Clear all

tsamisa

Skupina: Registrovaný

Přidal se: 2019/01/30

Estimable Member

	Well i got my first end to end successful print with a 0.4 n... In forum How do I print this? (Printing help)	před 6 years
	i guess you are right about the actually reading a lot into ... In forum How do I print this? (Printing help)	před 6 years
	After playing around with settings more it seems that the pr... In forum How do I print this? (Printing help)	před 6 years
	I tried the speed recommendations and reducing to 50% speed ... In forum How do I print this? (Printing help)	před 6 years
	i was using the 7x7 but return back to 3x3 since it wasn't m... In forum How do I print this? (Printing help)	před 6 years
	Thanks for your recommendations. I already reduced the volum... In forum How do I print this? (Printing help)	před 6 years
	Printing with colorfabb copperfill In forum How do I print this? (Printing help)	před 6 years
	I finally, with the help and patience of the support , limit... In forum General discussion, announcements and releases	před 6 years
	I have the same problem with you with PVA (along with loadin... In forum Hardware, firmware and software help	před 6 years
	Yet another loading issue with MMU2S. In forum General discussion, announcements and releases	před 6 years
	I really sympathize. After following the excellent instructi... In forum General discussion, announcements and releases	před 6 years

Stránka 11 / 11 Předchozí

Fórum Statistiky

565 Fóra

63.6 K Témata

446.1 K Příspěvky

22 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed