Prusa3D Forum

Notifications

Clear all

Tris

Grupa: Zarejestrowany

Dołączył: 2019/02/22

Active Member

	OK, found it under the expert tab in Prusa Slicer, many than... In forum How do I print this? (Printing help)	5 years temu
	One quick newbie question on using your g-code @bobstro, whe... In forum How do I print this? (Printing help)	5 years temu
	Thanks @bobstro, it's usually between the prime line and the... In forum How do I print this? (Printing help)	5 years temu
	Apart from the Z offset, I am pretty much using the default ... In forum How do I print this? (Printing help)	5 years temu
	I've been doing a bit more research and I suspect what I am ... In forum How do I print this? (Printing help)	5 years temu
	Loose filament spoiling first few layers In forum How do I print this? (Printing help)	5 years temu
	I've got the same issue on a MK3S kit I built at the weekend... In forum Assembly and first prints troubleshooting	6 years temu
	Hey and welcome to the OP (and everyone else). Me and my g... In forum General discussion, announcements and releases	6 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.3 K Posty

22 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte