Prusa3D Forum

Notifications

Clear all

Tris

Skupina: Registrovaný

Přidal se: 2019/02/22

Active Member

	OK, found it under the expert tab in Prusa Slicer, many than... In forum How do I print this? (Printing help)	před 5 years
	One quick newbie question on using your g-code @bobstro, whe... In forum How do I print this? (Printing help)	před 5 years
	Thanks @bobstro, it's usually between the prime line and the... In forum How do I print this? (Printing help)	před 5 years
	Apart from the Z offset, I am pretty much using the default ... In forum How do I print this? (Printing help)	před 5 years
	I've been doing a bit more research and I suspect what I am ... In forum How do I print this? (Printing help)	před 5 years
	Loose filament spoiling first few layers In forum How do I print this? (Printing help)	před 5 years
	I've got the same issue on a MK3S kit I built at the weekend... In forum Assembly and first prints troubleshooting	před 6 years
	Hey and welcome to the OP (and everyone else). Me and my g... In forum General discussion, announcements and releases	před 6 years

Fórum Statistiky

559 Fóra

63 K Témata

443.3 K Příspěvky

20 Online

67.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed