Prusa3D Forum

Notifications

Clear all

Tris

Groupe: Enregistré

A(ont) rejoint: 2019/02/22

Active Member

	OK, found it under the expert tab in Prusa Slicer, many than... Dans le forum How do I print this? (Printing help)	il y a 5 years
	One quick newbie question on using your g-code @bobstro, whe... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Thanks @bobstro, it's usually between the prime line and the... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Apart from the Z offset, I am pretty much using the default ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I've been doing a bit more research and I suspect what I am ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Loose filament spoiling first few layers Dans le forum How do I print this? (Printing help)	il y a 5 years
	I've got the same issue on a MK3S kit I built at the weekend... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Hey and welcome to the OP (and everyone else). Me and my g... Dans le forum General discussion, announcements and releases	il y a 6 years

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

23 En-ligne

67.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé