Prusa3D Forum

Notifications

Clear all

Trax Beaumont

Group: Registered

Joined: 2025/12/17

Active Member

	It's a little bit matte but otherwise it is completely norma... In forum Hardware, firmware and software help	3 weeks ago
	I apologize if I expressed myself unclearly. I got the print... In forum Hardware, firmware and software help	3 weeks ago
	After my new filament dryer is now in use, the moisture is a... In forum Hardware, firmware and software help	4 weeks ago
	A quick update: My new filament dryer should arrive tomorrow... In forum Hardware, firmware and software help	1 month ago
	This was PLA and I dried it at about 40°C for around 5 hours... In forum Hardware, firmware and software help	1 month ago
	Thank you very much for your ideas and suggestions so far. I... In forum Hardware, firmware and software help	1 month ago
	Troubleshooting - looking for ideas In forum Hardware, firmware and software help	1 month ago
	Here's a little addition: The camera does not work completel... In forum Buddy3D	2 months ago
	Thank you very much!! That fixed it. I just checked the inst... In forum Buddy3D	3 months ago
	Powering the Buddy3D on a Core One In forum Buddy3D	3 months ago

Forum Statistics

598 Forums

70.9 K Topics

496.8 K Posts

15 Online

82.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed