Aktivität
 
Benachrichtigungen
Alles löschen
Torpi
Torpi
Gruppe: Registriert
Beigetreten: 2022/01/25
Active Member
1
Well, you would have to hack the PCB to be able to pilot it ...

Im Forum General discussion, announcements and releases

Vor 2 years
Well, I plan to test those materials, that’s why I got the e...

Im Forum General discussion, announcements and releases

Vor 2 years
Filter on while printing or after printing?

Im Forum General discussion, announcements and releases

Vor 2 years
OK, I give you that the model was thin and flexible, so vibr...

Im Forum How do I print this? (Printing help)

Vor 2 years
I don’t see any reason why not printing it on the opposite s...

Im Forum How do I print this? (Printing help)

Vor 2 years
I did a test with Cura (this is the first time I use it, so ...

Im Forum How do I print this? (Printing help)

Vor 2 years
Aside from the shifting problems, I see a very strange chang...

Im Forum How do I print this? (Printing help)

Vor 2 years
2nd try: with Classic and support, the area with supports is...

Im Forum How do I print this? (Printing help)

Vor 2 years
I started a new print and will report on the position if the...

Im Forum How do I print this? (Printing help)

Vor 2 years
I suspect the Arachne mode vs Classic. I see one little bump...

Im Forum How do I print this? (Printing help)

Vor 2 years
Can you just confirm the problem is on the first layer side?...

Im Forum How do I print this? (Printing help)

Vor 2 years
Scratch / Quality issue in the middle of the print

Im Forum How do I print this? (Printing help)

Vor 2 years
Modifier with Fuzzy Skin

Im Forum PrusaSlicer

Vor 3 years
Teilen: