Prusa3D Forum

Notifications

Clear all

tomp33

Grupa: Zarejestrowany

Dołączył: 2023/02/09

Active Member

	Thank you, Diem, that worked! I heated the nozzle to PLA + ... In forum Hardware, firmware and software help	9 months temu
	Thank you, Diem! I had a feeling that something was stuck i... In forum Hardware, firmware and software help	9 months temu
	Ran out of filament, now unable to autoload In forum Hardware, firmware and software help	9 months temu
	I tried the "live Z adjust" calibration method, and I have a... In forum Hardware, firmware and software help	2 years temu
	Thank you -- there is a lot more to this than I expected! ... In forum Hardware, firmware and software help	2 years temu
	I did slice with PETG profile, used PrusaSlicer with the def... In forum Hardware, firmware and software help	2 years temu
	Newbie: failure with first PETG print, now calibration fails In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

559 Fora

62.8 K Tematy

442.2 K Posty

21 Online

67.3 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte