Prusa3D Forum

Notifications

Clear all

tomp33

Skupina: Registrovaný

Přidal se: 2023/02/09

Active Member

	Thank you, Diem, that worked! I heated the nozzle to PLA + ... In forum Hardware, firmware and software help	před 9 months
	Thank you, Diem! I had a feeling that something was stuck i... In forum Hardware, firmware and software help	před 9 months
	Ran out of filament, now unable to autoload In forum Hardware, firmware and software help	před 9 months
	I tried the "live Z adjust" calibration method, and I have a... In forum Hardware, firmware and software help	před 2 years
	Thank you -- there is a lot more to this than I expected! ... In forum Hardware, firmware and software help	před 2 years
	I did slice with PETG profile, used PrusaSlicer with the def... In forum Hardware, firmware and software help	před 2 years
	Newbie: failure with first PETG print, now calibration fails In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.2 K Příspěvky

21 Online

67.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed