Notifications
Clear all
tomp33
Groupe: Enregistré
A(ont) rejoint: 2023/02/09
Active Member
1
|
Thank you, Diem, that worked! I heated the nozzle to PLA + ... Dans le forum Hardware, firmware and software help |
il y a 10 months | |
|
Thank you, Diem! I had a feeling that something was stuck i... Dans le forum Hardware, firmware and software help |
il y a 10 months | |
|
Ran out of filament, now unable to autoload Dans le forum Hardware, firmware and software help |
il y a 10 months | |
|
I tried the "live Z adjust" calibration method, and I have a... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Thank you -- there is a lot more to this than I expected! ... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
I did slice with PETG profile, used PrusaSlicer with the def... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Newbie: failure with first PETG print, now calibration fails Dans le forum Hardware, firmware and software help |
il y a 2 years |