Français
Forums
Membres
tjmitchem
Activité
 
Notifications
Clear all
tjmitchem
tjmitchem
Groupe: Enregistré
A(ont) rejoint: 2021/06/30
Active Member
1
Profil Activité
I hit an interesting error compiling the firmware on OpenSuS...

Dans le forum Hardware, firmware and software help

 il y a 12 months
That was worth the three coffees 🙂 Thank you very much!

Dans le forum Assembly and first prints troubleshooting

 il y a 12 months
170c is what the firmware is picking for calibration. I'm n...

Dans le forum Assembly and first prints troubleshooting

 il y a 12 months
Calibrating with Prusa PC Blend Carbon Fiber

Dans le forum Assembly and first prints troubleshooting

 il y a 12 months
Got it fixed. The filament got jammed up in the extruder, s...

Dans le forum General discussion, announcements and releases

 il y a 3 years
The filament is not stuck in the printhead. I tried another...

Dans le forum General discussion, announcements and releases

 il y a 3 years
Unable to unload filament on my Mini+

Dans le forum General discussion, announcements and releases

 il y a 3 years
*facepalm* Thank you.

Dans le forum PrusaSlicer

 il y a 3 years
PrusaSlicer 2.3.2 skirt question

Dans le forum PrusaSlicer

 il y a 3 years
Hot water and soap did the ticket. Thanks to everyone who a...

Dans le forum How do I print this? (Printing help)

 il y a 3 years
Getting glue off the smooth PEI sheet

Dans le forum How do I print this? (Printing help)

 il y a 3 years
I combined both of these suggestions and it printed with no ...

Dans le forum How do I print this? (Printing help)

 il y a 3 years
Printing the Olsson Nozzle torque wrench

Dans le forum How do I print this? (Printing help)

 il y a 3 years
@bogdanh Thanks. I did the same thing.

Dans le forum Assembly and first prints troubleshooting

 il y a 3 years
Assembly issue with the Y-axis cable

Dans le forum Assembly and first prints troubleshooting

 il y a 3 years
Partager :