Notifications
Clear all

Assembly issue with the Y-axis cable  

  RSS
tjmitchem
(@tjmitchem)
Active Member
Assembly issue with the Y-axis cable

According to the video, there's supposed to be an opening near the rear-right (facing it from the rear) of the electronics box to route the y-axis able through.  This is according to the manual and the video on youtube.

Unfortunately, I don't have this opening, so I'm kind of stuck until I figure out how to route this y-axis wire.

 

Any ideas?

 

Posted : 30/06/2021 1:34 am
BogdanH
(@bogdanh)
Honorable Member
RE: Assembly issue with the Y-axis cable

Assembly manual here says, there are two versions of mainboard box (see first two images). However, I'm pretty sure my didn't have any of those two holes for Y-cable and so I just used the hole for display cable which is big enough.

[Mini+] [MK3S+BEAR]

Posted : 30/06/2021 5:13 am
tjmitchem
(@tjmitchem)
Active Member
Topic starter answered:
RE: Assembly issue with the Y-axis cable

@bogdanh

Thanks.  I did the same thing.

 

Posted : 30/06/2021 12:39 pm
Share: