Prusa3D Forum

Notifiche

Cancella tutti

Thomas S.

Gruppo: Registrato

Registrato: 2017/12/11

Active Member

	Top solid infill instead of perimeter Nel forum How do I print this? (Printing help)	6 years fa
	Is there any reason why the PE of Slicer don´t support Adapt... Nel forum General discussion, announcements and releases	6 years fa
	Thanks a lot 🙂 Got a better understanding what i have to t... Nel forum User mods - OctoPrint, enclosures, nozzles, ...	6 years fa
	Settings for printing with 0.6 nozzle Nel forum User mods - OctoPrint, enclosures, nozzles, ...	6 years fa
	So i got it 😀 Was my own fault. The belt was too tight. ... Nel forum Assembly and first prints troubleshooting	6 years fa
	Is it some kind of Layer Shift? Nel forum Assembly and first prints troubleshooting	6 years fa
	So today i tried with new firmware and 1.40 Version of slic3... Nel forum How do I print this? (Printing help)	6 years fa
	Hello! Are there any new Information on this issue? Did you... Nel forum How do I print this? (Printing help)	6 years fa
	Did not make any prints the last few days. Think my next ste... Nel forum How do I print this? (Printing help)	6 years fa
	Thanks for the hint with retraction speed. But for the momen... Nel forum How do I print this? (Printing help)	6 years fa
	I´m using default settings from Prusa PET for cooling. Keef ... Nel forum How do I print this? (Printing help)	6 years fa
	For the moment it feels quite disappointing for me. I tried ... Nel forum How do I print this? (Printing help)	6 years fa
	Thanks for your help. So i changed Settings to the following... Nel forum How do I print this? (Printing help)	7 years fa
	Problem with stringing on Black PETG Nel forum How do I print this? (Printing help)	7 years fa

Statistiche Forum

559 Forum

63 K Discussioni

443.6 K Post

21 Online

67.9 K Utenti

Post recenti: Adding Support around screw holes Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso