Prusa3D Forum

Notifications

Clear all

Thomas S.

Groupe: Enregistré

A(ont) rejoint: 2017/12/11

Active Member

	Top solid infill instead of perimeter Dans le forum How do I print this? (Printing help)	il y a 7 years
	Is there any reason why the PE of Slicer don´t support Adapt... Dans le forum General discussion, announcements and releases	il y a 7 years
	Thanks a lot 🙂 Got a better understanding what i have to t... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 7 years
	Settings for printing with 0.6 nozzle Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 7 years
	So i got it 😀 Was my own fault. The belt was too tight. ... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Is it some kind of Layer Shift? Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	So today i tried with new firmware and 1.40 Version of slic3... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Hello! Are there any new Information on this issue? Did you... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Did not make any prints the last few days. Think my next ste... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Thanks for the hint with retraction speed. But for the momen... Dans le forum How do I print this? (Printing help)	il y a 7 years
	I´m using default settings from Prusa PET for cooling. Keef ... Dans le forum How do I print this? (Printing help)	il y a 7 years
	For the moment it feels quite disappointing for me. I tried ... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Thanks for your help. So i changed Settings to the following... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Problem with stringing on Black PETG Dans le forum How do I print this? (Printing help)	il y a 7 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.3 K Messages

15 En-ligne

75.8 K Membres

Le dernier des messages: Schlechtere Qualität mit Octoprint!? Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé