Prusa3D Forum

Notifiche

Cancella tutti

thomas.b5

Gruppo: Registrato

Registrato: 2016/05/30

Eminent Member

	This is the new g code. Nel forum Prusa i3 kit (Archive)	10 years fa
	New try, 60% speed, 200°C, result still not as good as it co... Nel forum Prusa i3 kit (Archive)	10 years fa
	After modifying the extrusion width (to 0.4) and the z calib... Nel forum Prusa i3 kit (Archive)	10 years fa
	I use the firmware 3.0.3 with a first layer height of 0.2 mm... Nel forum Prusa i3 kit (Archive)	10 years fa
	So, I tried with new settings (0.4 extrusion width) and the ... Nel forum Prusa i3 kit (Archive)	10 years fa
	Thanks for your help. How can I do that ? Nel forum Prusa i3 kit (Archive)	10 years fa
	Thanks ! The gcode : Nel forum Prusa i3 kit (Archive)	10 years fa
	Sorry I don't how to do it... Nel forum Prusa i3 kit (Archive)	10 years fa
	Hello and sorry for the waiting. The link for the medallion... Nel forum Prusa i3 kit (Archive)	10 years fa
	So this is the result with printing 50 microns, fan speed at... Nel forum Prusa i3 kit (Archive)	10 years fa
	Here are some printings in 50 microns (while printing). Nel forum Prusa i3 kit (Archive)	10 years fa
	These are some printings in 100 microns if it can give you a... Nel forum Prusa i3 kit (Archive)	10 years fa
	I'm going to do that. Thanks for your help. Nel forum Prusa i3 kit (Archive)	10 years fa
	Thanks for your help. Concerning the thermistor, how can I k... Nel forum Prusa i3 kit (Archive)	10 years fa
	I use the PLA sent with the machine. It has been out of the ... Nel forum Prusa i3 kit (Archive)	10 years fa
	Hello ! So it seems to be a hardware problem because I used... Nel forum Prusa i3 kit (Archive)	10 years fa
	Alright, I will try this tomorrow. Do I have to change setti... Nel forum Prusa i3 kit (Archive)	10 years fa
	Re: Problems while printing 50 microns Nel forum Prusa i3 kit (Archive)	10 years fa
	I took this marvin from the sd card provided and put it in s... Nel forum Prusa i3 kit (Archive)	10 years fa
	Thanks for your answer. Where can I find the information co... Nel forum Prusa i3 kit (Archive)	10 years fa

Pagina 1 / 2 Avanti

Statistiche Forum

595 Forum

70.3 K Discussioni

492.3 K Post

14 Online

81.7 K Utenti

Post recenti: Lifting/warping specific to Core One Ultimo utente registrato: Tocri77 Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso