Prusa3D Forum

Benachrichtigungen

Alles löschen

thomas.b5

Gruppe: Registriert

Beigetreten: 2016/05/30

Eminent Member

	This is the new g code. Im Forum Prusa i3 kit (Archive)	Vor 8 years
	New try, 60% speed, 200°C, result still not as good as it co... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	After modifying the extrusion width (to 0.4) and the z calib... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I use the firmware 3.0.3 with a first layer height of 0.2 mm... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	So, I tried with new settings (0.4 extrusion width) and the ... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Thanks for your help. How can I do that ? Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Thanks ! The gcode : Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Sorry I don't how to do it... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Hello and sorry for the waiting. The link for the medallion... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	So this is the result with printing 50 microns, fan speed at... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	Here are some printings in 50 microns (while printing). Im Forum Prusa i3 kit (Archive)	Vor 8 years
	These are some printings in 100 microns if it can give you a... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I'm going to do that. Thanks for your help. Im Forum Prusa i3 kit (Archive)	Vor 9 years
	Thanks for your help. Concerning the thermistor, how can I k... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	I use the PLA sent with the machine. It has been out of the ... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	Hello ! So it seems to be a hardware problem because I used... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	Alright, I will try this tomorrow. Do I have to change setti... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	Re: Problems while printing 50 microns Im Forum Prusa i3 kit (Archive)	Vor 9 years
	I took this marvin from the sd card provided and put it in s... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	Thanks for your answer. Where can I find the information co... Im Forum Prusa i3 kit (Archive)	Vor 9 years

Seite 1 / 2 Nächstes

Forums-Statistiken

565 Foren

63.8 K Themen

447.3 K Beiträge

24 Online

69.4 K Mitglieder

Letzter Beitrag: GPIO Project Question - Filter control Unser neuestes Mitglied: SilenceDIY Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen