Prusa3D Forum

Notifications

Clear all

thomas.b5

Groupe: Enregistré

A(ont) rejoint: 2016/05/30

Eminent Member

	This is the new g code. Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	New try, 60% speed, 200°C, result still not as good as it co... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	After modifying the extrusion width (to 0.4) and the z calib... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I use the firmware 3.0.3 with a first layer height of 0.2 mm... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	So, I tried with new settings (0.4 extrusion width) and the ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Thanks for your help. How can I do that ? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Thanks ! The gcode : Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Sorry I don't how to do it... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Hello and sorry for the waiting. The link for the medallion... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	So this is the result with printing 50 microns, fan speed at... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Here are some printings in 50 microns (while printing). Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	These are some printings in 100 microns if it can give you a... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I'm going to do that. Thanks for your help. Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Thanks for your help. Concerning the thermistor, how can I k... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I use the PLA sent with the machine. It has been out of the ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hello ! So it seems to be a hardware problem because I used... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Alright, I will try this tomorrow. Do I have to change setti... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Re: Problems while printing 50 microns Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I took this marvin from the sd card provided and put it in s... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Thanks for your answer. Where can I find the information co... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.8 K Sujets

447.3 K Messages

21 En-ligne

69.4 K Membres

Le dernier des messages: Prusa slcr 2.9.0 continuos crash MacBook Pro M1 Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé