Attività
 
Notifiche
Cancella tutti
thomas
thomas
Gruppo: Registrato
Registrato: 2022/05/25
Active Member
1
Sorry for the very late reply, I did a maintenance and tight...

Nel forum Hardware, firmware and software help

7 months fa
Thank you for your answer, I'll do all the maintenance steps...

Nel forum Hardware, firmware and software help

7 months fa
Random printing issues

Nel forum Hardware, firmware and software help

7 months fa
I have checked the bed surface with Bed Vizualiser plugin fr...

Nel forum Hardware, firmware and software help

2 years fa
Thanks for your feedback @robin I know it's not for my first...

Nel forum Hardware, firmware and software help

2 years fa
Hello everyone, I have printed another test for my first l...

Nel forum Hardware, firmware and software help

2 years fa
I have cleaned my bed and ran a first layer calibration The ...

Nel forum Hardware, firmware and software help

2 years fa
Well after leaving it continue even with such an ugly first ...

Nel forum Hardware, firmware and software help

2 years fa
The bed is clean Could it be the PTFE tube that are getting ...

Nel forum Hardware, firmware and software help

2 years fa
What is weird is, it's only happening on one side of the pri...

Nel forum Hardware, firmware and software help

2 years fa
infill issues

Nel forum Hardware, firmware and software help

2 years fa
I was noticing the same behavior with Mini+ too when loading...

Nel forum PrusaSlicer

2 years fa
Ok noted, thank you for your advice.

Nel forum General discussion, announcements and releases

2 years fa
Printing help and questions

Nel forum General discussion, announcements and releases

3 years fa
Condividi: