Notifications
Clear all
thomas
thomas
Skupina: Registrovaný
Přidal se: 2022/05/25
Active Member
1
Sorry for the very late reply, I did a maintenance and tight...

In forum Hardware, firmware and software help

před 7 months
Thank you for your answer, I'll do all the maintenance steps...

In forum Hardware, firmware and software help

před 7 months
Random printing issues

In forum Hardware, firmware and software help

před 7 months
I have checked the bed surface with Bed Vizualiser plugin fr...

In forum Hardware, firmware and software help

před 2 years
Thanks for your feedback @robin I know it's not for my first...

In forum Hardware, firmware and software help

před 2 years
Hello everyone, I have printed another test for my first l...

In forum Hardware, firmware and software help

před 2 years
I have cleaned my bed and ran a first layer calibration The ...

In forum Hardware, firmware and software help

před 2 years
Well after leaving it continue even with such an ugly first ...

In forum Hardware, firmware and software help

před 2 years
The bed is clean Could it be the PTFE tube that are getting ...

In forum Hardware, firmware and software help

před 2 years
What is weird is, it's only happening on one side of the pri...

In forum Hardware, firmware and software help

před 2 years
infill issues

In forum Hardware, firmware and software help

před 2 years
I was noticing the same behavior with Mini+ too when loading...

In forum PrusaSlicer

před 2 years
Ok noted, thank you for your advice.

In forum General discussion, announcements and releases

před 2 years
Printing help and questions

In forum General discussion, announcements and releases

před 3 years
Share: