Prusa3D Forum

Notifications

Clear all

TheBobGeezer

Skupina: Registrovaný

Přidal se: 2022/03/05

Active Member

	Oh, you star! I was adjusting in the 0.1 to 0.2 mm range and... In forum Hardware, firmware and software help	před 3 years
	Thanks fuchsr. Apart from my reservations about this, how a... In forum Hardware, firmware and software help	před 3 years
	Oh, I do not want to mess with the PINDA sensor. It was set... In forum Hardware, firmware and software help	před 3 years
	Z no longer goes low enough In forum Hardware, firmware and software help	před 3 years
	I found it was caused by a fragment of PLA trapped under the... In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

567 Fóra

65 K Témata

454.7 K Příspěvky

19 Online

71.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed