Prusa3D Forum

Notifications

Clear all

tdashadow

Grupa: Zarejestrowany

Dołączył: 2021/04/16

Active Member

	it was newly opened bag of PLA and I use dryer. Nozzle was c... In forum How do I print this? (Printing help)	3 years temu
	I tried PETG and it prints fine. So clearly no mechanical p... In forum How do I print this? (Printing help)	3 years temu
	i did clean nozzle checked everything and next print was fin... In forum How do I print this? (Printing help)	3 years temu
	Issue printing round objects In forum How do I print this? (Printing help)	3 years temu
	I had similar issue. Had to move SuperPinda sensor up a bit ... In forum Hardware, firmware and software help	4 years temu
	I got prebuilt Mini+ and there was nothing in the manual, bu... In forum General discussion, announcements and releases	4 years temu
	I have same issue with the textured PEI. Smooth is at -1.903 In forum General discussion, announcements and releases	4 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.7 K Posty

21 Online

67.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte