Prusa3D Forum

Benachrichtigungen

Alles löschen

tdashadow

Gruppe: Registriert

Beigetreten: 2021/04/16

Active Member

	it was newly opened bag of PLA and I use dryer. Nozzle was c... Im Forum How do I print this? (Printing help)	Vor 3 years
	I tried PETG and it prints fine. So clearly no mechanical p... Im Forum How do I print this? (Printing help)	Vor 3 years
	i did clean nozzle checked everything and next print was fin... Im Forum How do I print this? (Printing help)	Vor 3 years
	Issue printing round objects Im Forum How do I print this? (Printing help)	Vor 3 years
	I had similar issue. Had to move SuperPinda sensor up a bit ... Im Forum Hardware, firmware and software help	Vor 4 years
	I got prebuilt Mini+ and there was nothing in the manual, bu... Im Forum General discussion, announcements and releases	Vor 4 years
	I have same issue with the textured PEI. Smooth is at -1.903 Im Forum General discussion, announcements and releases	Vor 4 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.7 K Beiträge

19 Online

67.6 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen