Prusa3D Forum

Notifiche

Cancella tutti

tdashadow

Gruppo: Registrato

Registrato: 2021/04/16

Active Member

	it was newly opened bag of PLA and I use dryer. Nozzle was c... Nel forum How do I print this? (Printing help)	3 years fa
	I tried PETG and it prints fine. So clearly no mechanical p... Nel forum How do I print this? (Printing help)	3 years fa
	i did clean nozzle checked everything and next print was fin... Nel forum How do I print this? (Printing help)	3 years fa
	Issue printing round objects Nel forum How do I print this? (Printing help)	3 years fa
	I had similar issue. Had to move SuperPinda sensor up a bit ... Nel forum Hardware, firmware and software help	4 years fa
	I got prebuilt Mini+ and there was nothing in the manual, bu... Nel forum General discussion, announcements and releases	4 years fa
	I have same issue with the textured PEI. Smooth is at -1.903 Nel forum General discussion, announcements and releases	4 years fa

Statistiche Forum

559 Forum

62.9 K Discussioni

442.7 K Post

18 Online

67.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso