Notifications
Clear all
taxilian
taxilian
Group: Registered
Joined: 2016/10/20
Active Member
1
If you look really closely at the black piece that broke off...

In forum Others (Archive)

8 years ago
This is my third print at that temperature and the last two ...

In forum Others (Archive)

8 years ago
I haven't made any changes; I am using the prusa supplied co...

In forum Others (Archive)

8 years ago
I've now run a hardened nozzle in two different printers for...

In forum Others (Archive)

8 years ago
Hi Chris, So the heat issue I've been having it turns out i...

In forum Others (Archive)

8 years ago
While it did take me a bit to dial it in, it's been working ...

In forum Others (Archive)

8 years ago
So I installed the printbite from mutley (bought on flex3dri...

In forum Others (Archive)

8 years ago
For the most part I haven't had any issue with the parts ins...

In forum Others (Archive)

8 years ago
I had a similar issue and ended up having to heat up the blo...

In forum Others (Archive)

8 years ago
I went for months with no idea why my old printer wasn't wor...

In forum Others (Archive)

8 years ago
That's an interesting perspective. I consider a rpi running...

In forum Others (Archive)

8 years ago
In my experience on the Mk2 (and naturally if it's in my exp...

In forum Others (Archive)

8 years ago
If you do try a z calibration be ready to kill it... I am pr...

In forum Others (Archive)

8 years ago
When you say that printbite may cause the probe not to work....

In forum Others (Archive)

8 years ago
I've not tried this personally (haven't printed PETG recentl...

In forum Others (Archive)

8 years ago
You really need to remove the original; adding an extra laye...

In forum Others (Archive)

8 years ago
My problem (I was the OP) is resolved now; I had measured th...

In forum Others (Archive)

8 years ago
Calibration... problem? sorta?

In forum Others (Archive)

8 years ago
I had the same issue; I checked cables, swapped them, etc fo...

In forum Prusa i3 kit (Archive)

8 years ago
Share: