Prusa3D Forum

Notifications

Clear all

taxilian

Groupe: Enregistré

A(ont) rejoint: 2016/10/20

Active Member

	If you look really closely at the black piece that broke off... Dans le forum Others (Archive)	il y a 8 years
	This is my third print at that temperature and the last two ... Dans le forum Others (Archive)	il y a 8 years
	I haven't made any changes; I am using the prusa supplied co... Dans le forum Others (Archive)	il y a 8 years
	I've now run a hardened nozzle in two different printers for... Dans le forum Others (Archive)	il y a 8 years
	Hi Chris, So the heat issue I've been having it turns out i... Dans le forum Others (Archive)	il y a 8 years
	While it did take me a bit to dial it in, it's been working ... Dans le forum Others (Archive)	il y a 8 years
	So I installed the printbite from mutley (bought on flex3dri... Dans le forum Others (Archive)	il y a 8 years
	For the most part I haven't had any issue with the parts ins... Dans le forum Others (Archive)	il y a 8 years
	I had a similar issue and ended up having to heat up the blo... Dans le forum Others (Archive)	il y a 8 years
	I went for months with no idea why my old printer wasn't wor... Dans le forum Others (Archive)	il y a 8 years
	That's an interesting perspective. I consider a rpi running... Dans le forum Others (Archive)	il y a 8 years
	In my experience on the Mk2 (and naturally if it's in my exp... Dans le forum Others (Archive)	il y a 8 years
	If you do try a z calibration be ready to kill it... I am pr... Dans le forum Others (Archive)	il y a 8 years
	When you say that printbite may cause the probe not to work.... Dans le forum Others (Archive)	il y a 8 years
	I've not tried this personally (haven't printed PETG recentl... Dans le forum Others (Archive)	il y a 8 years
	You really need to remove the original; adding an extra laye... Dans le forum Others (Archive)	il y a 8 years
	My problem (I was the OP) is resolved now; I had measured th... Dans le forum Others (Archive)	il y a 8 years
	Calibration... problem? sorta? Dans le forum Others (Archive)	il y a 8 years
	I had the same issue; I checked cables, swapped them, etc fo... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

22 En-ligne

68 K Membres

Le dernier des messages: XL USB C Camera from the CORE Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé