Prusa3D Forum

Notifications

Clear all

taxilian

Grupa: Zarejestrowany

Dołączył: 2016/10/20

Active Member

	If you look really closely at the black piece that broke off... In forum Others (Archive)	8 years temu
	This is my third print at that temperature and the last two ... In forum Others (Archive)	8 years temu
	I haven't made any changes; I am using the prusa supplied co... In forum Others (Archive)	8 years temu
	I've now run a hardened nozzle in two different printers for... In forum Others (Archive)	8 years temu
	Hi Chris, So the heat issue I've been having it turns out i... In forum Others (Archive)	8 years temu
	While it did take me a bit to dial it in, it's been working ... In forum Others (Archive)	8 years temu
	So I installed the printbite from mutley (bought on flex3dri... In forum Others (Archive)	8 years temu
	For the most part I haven't had any issue with the parts ins... In forum Others (Archive)	8 years temu
	I had a similar issue and ended up having to heat up the blo... In forum Others (Archive)	8 years temu
	I went for months with no idea why my old printer wasn't wor... In forum Others (Archive)	8 years temu
	That's an interesting perspective. I consider a rpi running... In forum Others (Archive)	8 years temu
	In my experience on the Mk2 (and naturally if it's in my exp... In forum Others (Archive)	8 years temu
	If you do try a z calibration be ready to kill it... I am pr... In forum Others (Archive)	8 years temu
	When you say that printbite may cause the probe not to work.... In forum Others (Archive)	8 years temu
	I've not tried this personally (haven't printed PETG recentl... In forum Others (Archive)	8 years temu
	You really need to remove the original; adding an extra laye... In forum Others (Archive)	8 years temu
	My problem (I was the OP) is resolved now; I had measured th... In forum Others (Archive)	8 years temu
	Calibration... problem? sorta? In forum Others (Archive)	8 years temu
	I had the same issue; I checked cables, swapped them, etc fo... In forum Prusa i3 kit (Archive)	8 years temu

Statystyki Forum

565 Fora

64.5 K Tematy

451.8 K Posty

25 Online

71.1 K Członkowie

Ostatni Post: Straightening filament..... Najnowszy użytkownik:: baztm Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte